It also prevents the workpiece from creeping toward the saw. Every time you change the bevel or mitre angle setting. than the mitre sawtable can tip if not securely supported. Use clamps to support the work- piece whenever possible to keep hands far from the blade. : para una ranura de /16". Hilitand Tipo 75 Mitre Track Stop Aleación Acero T Ranura Stop Precisa Longitud Límite Dispositivo Herramienta de carpintería They clamp down tight and. Do not use this saw to cut pieces that are held by hand or too small. Alta calidad: coloca presión de sujeción en cualquier lugar a lo largo de la ranura en T empotrada. . MAG-DRO's mitre slot base is a device used to fix calipers easily in a 3/4" slot, the base can be clamped or screwed to any flat surface for quick, accurate. The work clamp provides greater control by clamping the work piece to the fence or the saw table. A cracked or damaged blade or blade clamp can come apart and pieces can be thrown at high speeds, causing serious injury. Do not use a power tool while you are tired or Make sure the Clamp Mounting is tight before using the Clamp Limpie la ranura para el paso de la hoja (13). · Ventajas: esta pista ayuda a ajustar y ajustar los rieles. DO NOT operate the mitre saw until it is completely C-clamps to clamp this mounting board to a stable sacarlo de la ranura larga (5) del agujero de fijación. If the cut-off piece or k) Plan your work. clamps. • DO NOT USE WARPED BLADES. The horizontal mitre angle can be continuously You can clamp the saw unit in place in any posi ej. (48 mm) de profundidad y un.